380UT Liftmaster Universal 2-button Garage Door Opener Remote

380UT Liftmaster Universal 2-button Garage Door Opener Remote

**380UT REMOTE DISCONTINUED - use the new L992U 2-Button Remote found here.

A universal remote that's compatible with many Liftmaster, Chamberlain, Sears, Raynor, Genie, Linear, Stanley, MultiCode and Wayne Dalton garage door openers (see below). The 380UT Remote has two buttons that can be programmed to two different brands of garage door openers and replaces the previous model 375UT.

Features

• Tri-band operating frequency
• Buttons are independent so it can control two different garage door manufacturers/frequencies at the same time
• Increased compatibility available with Wayne Dalton®, Genie® Intellicode, Stanley® SecureCode, and more
• Directional visor clip
• Coin cell battery included
• Programming instructions included

Compatibility

Compatible with the following brands:

• Genie®: Genie Overhead Door Intellicode 1995-current; Genie Overhead Door Intellicode 2005-current, 390MHz Dip Switch (9 or 12 position)
• Linear®: Linear Mega-Code 1997-current; Linear Multicode (10 DIP switch); Linear Delta 3 (8 DIP switch)
• Stanley®: Stanley MultiCode (10 DIP switch)
• Wayne-Dalton®: Wayne Dalton Rolling Code 372.5MHz 1999-current
• LiftMaster® / Chamberlain® / Craftsman® / Raynor
  • Remotes from 1990-1992 9-DIP switches (Red LED): 61LM, 62LM, 63LM, 64LM
  • Remotes from 1993-1997 Billion Code (Green LED): 81LM, 82LM, 83LM, 84LM, 99LM; Green Learn Button
  • Remotes from 1997-2005 Rolling Code Security+ 390MHz: 971LM, 972LM, 973LM, 974LM, 970LM; Orange Learn Button
  • Remotes from 2005-current Rolling Code Security+ 315MHz: 371LM, 372LM, 373LM, 374LM; Purple Learn Button
  • Remotes from 2011-current Security+2.0: 811LM, 813LM, 891LM, 893LM, 893MAX, 890MAX, 895MAX; Yellow Learn Button

• Not compatible with Marantec or Hormann garage door openers.

*Note about programming to a Linear Delta-3 Radio Receiver - the instructions indicate that you need to press the remote button (18) times during programming but we found that doesn't always work so try pressing the remote button (21) times.