HAE00002 Linear Garage Door Opener Safety Sensors
Are you
troubleshooting your Linear LDO50, LDO33 or other model garage door
opener? Having problems with the garage door opener not closing unless
you hold the button down on the wall? Will the remote control open the
door but not close it? These are all indications that there's an issue
with the Linear garage door sensors.
The garage door opener
safety sensors may be out of alignment or there could be a pinched or
broken wire going to one of the sensors. If you've checked those
possibilities and found nothing wrong then it's possible the safety
sensors have failed and need replaced. The HAE00002 Linear Sensors come
as a pair - one sending sensor and one receiving sensor. They include a
short wire to splice into your existing sensor wires. Optional gel cap
wire connectors are available to include with the safety sensors.
Features
- Linear Garage Door Opener Safety Sensors
- Part no.: HAE00002 / New Part no.: HAE00087
- Includes: One (1) Sender safety sensor and one (1) Receiver sensor
- Optional: mounting brackets, sensor wire, and splicing gel caps are not included but are available from the optional checkbox menu
Compatibility
- Compatible with Linear Garage Door Opener models: NICE Linear 661, LDCO863B, LDCO852, LDCO850, LDCO841, LDC801, LDCO800, LSO50, LDO33, LDO50, LCO75
- Complete pair (sender and receiver)
- Does not include mounting brackets or wire
OPTIONS - optional products to purchase with the Safety Sensors
Option #1: Add Linear Safety Sensor Brackets - includes two safety sensor brackets to mount the HAE00002 (HAE00087) Safety Sensors
Option #2: Add Safety Sensor Brackets & 40 ft. 2-Strand Wire - includes one pair of safety sensor brackets and 40 feet of 2-strand wire to connect safety sensors to the operator
Option #3: Add 40 ft 2-Strand Wire & (4) Gel Cap Wire Connectors - includes 40 feet of 2-strand wire and (4) wire connectors to connect the wire from the new wire to the sensors
Option #4: Add Sensor Brackets, 40 ft. Wire, and (4) Wire Connectors - includes one pair sensor brackets, wire and (4) wire connectors
Option #5: Add four (4) Gel Cap Wire Connectors - includes (4) wire connectors to connect your existing wire to the new safety sensors
*Troubleshooting your opener and need a Linear manual? Check out our Support Manuals site for Linear opener manuals.