CR-2154 Digi-Code Photo-electric Safety Sensors (pair)
The Digi-Code CR2154 Safety Sensors replace the PEC-R3 (4050727) Raynor garage door opener photo-electric safety sensors.
- CR-2154
Digi-Code replacement sensors. The original Raynor PEC-R3 Safety
Sensors manufactured by Raynor are no longer available. The CR-2154
Sensors are the only compatible sensors currently available to replace the original
Raynor PEC-R3 Sensors.
- Includes both the Emitter Sensor and Receiver Sensor
- Includes new sensor mounting brackets, mounting screws for brackets & instructions
- Not Included: Wire to connect sensors to opener
- Note:
These sensors are slightly different and will not mount to the original
PEC-R3 sensor brackets. The new CR-2154 Sensors require new mounting
brackets (included) to be installed.
- For use
with the Raynor R160/R260 model opener and some of the R170/R270 model
operators. Some of the Raynor R170 openers used PEC-R4 sensors - check
yours and make sure you order the correct model of sensors.
- DETERMINE WHICH SENSORS YOU NEED BEFORE ORDERING.
If there's 3 wires on one sensors and 2 wires in the other sensor then
the sensors are PEC-R3 sensors. If you have 2 wires coming out of each
sensor then you have the PEC-R4 sensors. Unfortunately Raynor
Manufacturing discontinued the PEC-R4 Sensors in Feb. 2014 - there are
no replacements available for the PEC-R4 Sensors.
- If
you need sensors for any of the other Raynor openers (Admiral, Aviator,
Airman, Commander, Corporal, Endeavor, General II, Navigator, Pilot,
Prodigy, Sergeant II, or Ultra) use the Liftmaster 041-0136 Safety Sensors.