881LMW Liftmaster Wi-Fi Motion Detecting Wall Control Panel with Timer-to-Close
Compatible with various Liftmaster and Raynor MyQ Security+2.0 garage door operators
The 881LMW is a wired wall control panel for Liftmaster and Raynor Security+2.0 openers. It works with the same operators as the 886LMW Motion Detecting Wall Control Panel. Both panels include motion-activated opener lights, lock, light control, remote and keypad programming, Wi-Fi setup on compatible openers, and the Maintenance Alert System. The 881LMW also adds Timer-to-Close, which can automatically close a sectional garage door after 1, 5, or 10 minutes.
The motion sensor turns the opener lights on when you walk into the garage. The lights stay on for 4-1/2 minutes so you can see your way around. Timer-to-Close is for sectional doors only. It will not operate a one-piece door, will not run while the opener is on battery backup, and will not close the door if the safety reversing sensors are blocked or out of alignment.
Features
- Liftmaster Security+2.0 Wi-Fi Motion Detecting Wall Control Panel with Timer-to-Close
- Model no.: 881LMW
- Timer-to-Close (TTC): Automatically closes a sectional garage door after 1, 5, or 10 minutes. Can be paused with Hold Open. For sectional doors only
- Motion Detection: Turns on the garage door operator light as soon as you walk in. The light will remain on for 4-1/2 minutes
- Door Control Push Bar: Press to open or close the door. Press again to reverse the door during the close cycle or to stop the door while it's opening
- Light Feature: Press the Light button to switch the opener light on or off. When the door is open or closed the light will remain on for 4-1/2 minutes
- Lock Feature: Designed to prevent operation of the door from portable remote controls. However, the door will open and close from the Door Control Push Button and from a Keyless entry accessory
- Learn Button: Used to add, reprogram or change a remote control or keyless entry pin number
- Maintenance Alert System (MAS): When the garage door opener needs to be serviced (approx. 4500 garage door opener cycles) the command (yellow) and service (red) LEDs will begin to alternately flash back and forth
- Includes mounting screws and installation instructions
Compatibility
- The opener must have a Yellow Learn Button & Yellow Antenna and have Security+2.0 technology to be compatible
- Compatible with the following Liftmaster openers: 8550W, 8587W, 8557W, 8360W, 8355W, 8365W-267, 8160, 8165, 8155, 8065, 8010, 8550, 8587, 8557, 8360, 8355, 8365-267 (list not complete)
- Compatible with the following Raynor openers: Admiral II WiFi (8550WRGD), Admiral II (8550RGD), Airman II (8155RGD / 8155WRGD / 81550RGD), Aviator II (8355RGD), Corporal II (8165RGD / 8165WRGD / 81650RGD), General II (WLEDRGD), Pilot II (8365RGD / 8365RGD-267 / 83650RGD-267), Prodigy II (8500RGD), Prodigy III (98022RGD), Sentinel (85503RGD), Sentinel III (84505RGD), Sentinel 360 (87504RGD-267), Sergeant II (8160RGD / 8160WBRGD / 81600RGD / 81602RGD), Ultra II (8587RGD / 8587WRGD / 8587WLRGD / 85870RGD) and Voyager (84501RGD)
Bell wire is not included for connecting the wall control panel to the operator but can be purchased with the control panel by selecting the length you need from the Optional Drop Down Menu.