MTR1 Linear 1-button MegaCode Garage Door Opener Remote 318MHz
When the Linear 1-Button MTR1 MegaCode transmitter is programmed to a Linear garage door opener or Linear gate opener it uses a unique code when the remote button is pressed. Each transmitter is permanently coded at the factory and the radio receiver is programmed by learning the transmitters unique code.
The MTR1 comes with one (1) CR2032 3-volt lithium battery. The blue light on the Linear remote will glow when the button is pressed and sending a signal. If the blue light is dim then the remote battery should be replaced. Under normal use the batteries should last 3 years.
The Linear MTR1 remote is also compatible with Homelink. If your vehicle has the Homelink buttons (refer to your car owners manual) then the Homelink buttons in the car can be programmed using the Linear MTR1 remote after it has been programmed to the garage door opener. You can use the Homelink website here to find the specific programming instructions for your car and garage door opener.